Master slave ide

To allow for two drives on the same cable, IDE uses a special configuration called master and slave. With a pair of tweezers or needle-nose pliers, place the jumper (a little plastic thingy) across the correct pair of pins, either Master or Slave. I have a SATA drive and an IDE drive. Slave is one of two main settings for a hard disk. If you are building a computer you can set hard drives to be master or slave (Plus a few others depending on hard drive type (like cable select)).

Single, Master and Slave Drives and Jumpering.

You do this by changing the jumpers on the hard drive next to the power connector. Normally, the drive will have a diagram to let you know which . Connecting IDE Hard Drives. You Would Think It Was Simple, But. First, Master and Slave devices are different for the 80-wire cables and the 40-wire cables. When connecting IDE devices in your computer, there are a few rules you need to know about.

Primary Slave or Secondary Master ? Install IDE Hard Drive - A guide to installing IDE hard drive - This guide will take you through the process of how to install hard drive master slave , how to install an IDE hard drive jumper settings, how to connect IDE hard drive to motherboar and everything you need to know about installing an IDE hard drive.

In some systems a master is selected from a group of eligible devices, with the other devices acting in the role of slaves. An einem IDE -Kanal können nach der ATA-1- Spezifikation bis zu zwei Geräte betrieben werden. Kabel für die IDE -Schnittstelle besitzen daher meist zwei Laufwerksanschlüsse. Die Signale sind an jedem Stecker gleich und unterscheiden sich in ihrer Signallogik nicht. Ein Gerät lässt sich somit . My old HDD has a standard IDE serial connection.

I cannot get the machine to recognize the IDE. It is jumpered as a slave and . Does it matter which drive you plug into the slots on an IDE cable? When it came time to put in a bigger H we got the idea that we could use the old IDE HD to hold the OS, and the new SATA HD to hold all the user data. The SATA drive is a Seagate 80GB Barracuda.

SATA cables are thin and long and includes 7-pins. Is it just to save an IDE slot? They are now being used on most new computers. For all devices connected to a cable, is the maximum transfer speed of the bus limited to the speed of the slowest device?

I think I heard something like this for hard drives so I just . In a recent project for a customer, we were faced with having to swap IDE devices around on a fairly regular basis.

All IDE drives have jumpers that select the . Sorry, IDE is kind of new to me. Does the slave drive have to have the .