The cable tracker with tone generator features network tester: consists of a tone generator and a probe. Use the tone generator and the probe to determine where a cable is going and whether or not (and where) the cable is interrupted. Send a single solid tone or a dual alternating tone to the object cables or wires.
Shop with confidence on eBay! Toggle switch to control modes of operation3.
Network tester: consists of a tone generator and a probe. Features: Network Tester: consists of a tone generator and a probe. Method: use tone generator and the probe to determine where a cable is going and whether or not the cable is interrupted.
Signal viewing in modes - Lamp (L), Speaker (S), or both (LS). Amplifier Probe: The Amplifier Probe is designed to identify and trace wires or cables within a group without damaging the insulation. It allows for pin point identification even in the most congested cable bundles.
Our unit can be used with any tone generator.
The signal emitted by the tone generator can be easily traced by the companion probe, even when cables are in a bundle or hidden in punch down . Both a tone generator and receiver supplied with crocodile clips or RJ. CABLE TRACER TONE GENERATOR. Alligator clips and a standard RJplug allow the tone generator to be connected to stripped wires, terminal panels, wall plates, or modular single line jacks. The transmitter connects to un-energized cables , wires or fuses while the receiver probe traces the wire path. Features: network tester: consists of a tone generator and a probe method: use the tone generator and the probe to determine where a cable is going and whether or not (and where) the cable is interrupted.
If you are tracing a data line, you have to disconnect the patch cable from the server to the patch panel. If you do not disconnect the patch cable , you will get no signal from the tone generator. The server interferes with the signal.
Also, mentioned above, make sure the batteries are good in the tool. The TN1unit is designed for dead circuit tracing only and comes complete with an Amplifier probe and a Tone generator. The Amplifier probe is designed to identify and trace wires or cables within a group, without damaging the insulation. It is interchangeable with any tone generator to identify wires.
Tone tracing is pretty much as old as copper cabling itself. The basic idea is that at one end of the cable you place an electrical signal onto the cable, using a tone generator , and then trace that signal, using a tone tracer, in order to understand . The Amplifier Probe is designed to identify and trace wires or cables within a group without damaging the insulation.
L), speaker (SP) or both (SL) ? Tone Generator is great tool for locating and Identifying cable pairs or .
Ingen kommentarer:
Send en kommentar
Bemærk! Kun medlemmer af denne blog kan sende kommentarer.