Tl072 output current

Iq per channel (Typ) (mA). Operating Temperature Range (C). Input Bias Current (Max) (pA). Output Current (Typ) (mA). With these values I gave you, ohms law is the only other thing you need.

Regards, Ronald Michallick Linear Applications.

Each amplifier features JFET inputs (for high input impedance) coup°C with bipolar output stages integrated on a single monolithic chip. For example, the dual-supply OP-07:. By using negative feedback, the characteristics of an op-amp circuit, its gain, input and output impedance, bandwidth etc. Op- amps are among the most widely used electronic . LF44 TL0, TL0and OP-2sockets.

High Speed Op Amp Query Reply to Thread. What exactly are you looking for on these datasheets that tells you what the power handling of the device is? What are the power handling values of the TL0and OPA134?

A few inches of track can sometimes be enough. This can be cured by an isolating resistor, in the 47–O. DIFFERENTIAL VOLTAGE RANGE. LOW INPUT BIAS AND OFFSET CURRENT. OUTPUT SHORT-CIRCUIT PROTECTION.

LOW HARMONIC DISTORTION : 0. But most real world op- amps cannot swing their output. Maximum output voltage vs Frequency vs Free-air temperature. Datasheet - production data. High input impedance J-FET input stage. Internal frequency compensation.

JFET inputs (for high input impedance) coupled with bipolar output stages integrated on a single monolithic chip. Low harmonic distortion:0. PRODUCTION DATA information is current as of publication date. Products conform to specifications per the. The C-suffix devices are.

I thought from the datasheet that it needed at least 7V. I am running it on 5V, single-supply, so 2.

V at the positive input). I am using both stages of the TL0to reamp the input to a high enough output current to drive the BC550. V so the typical output current is 31mA.

LOW NOISE J-FET DUAL OPERATIONAL AMPLIFIERS. J–FET input dual operational.