Pololu motor driver

Single and dual motor driver carriers get your brushed DC motor projects up and running quickly using modern H-bridges with high-performance MOSFETs that deliver hundreds of watts in a compact package. Give these boards a PWM signal and make your motors go! A recommended motor voltage of 4. A per channel continuously (A peak) to a pair of DC motors. With an operating voltage range from 2.

V and built-in protection against reverse-voltage, under-voltage, over-current, and over-temperature, this driver is a great solution for . Take command of the speed and direction of your brushed DC motors using these controllers. A ( A peak) to a single brushed DC motor. This shield makes it easy to control two high-power DC motors with your Arduino or Arduino-compatible board. V and can deliver a continuous A (A peak) per motor, or a continuous A (A peak) to a single motor connected to. This family of pin-compatible, discrete MOSFET H-bridge motor drivers is suitable for bidirectional control of high-voltage or high-current DC brushed motors.

This discrete MOSFET H-bridge motor driver enables bidirectional control of one high-power DC brushed motor. V voltage range and is efficient enough to deliver a continuous A without a heat sink.

Additional features of this second-generation (G2) driver include . It is capable of delivering a continuous 0. V logic levels, supports ultrasonic (up to kHz) PWM, and features current sense feedback (an analog voltage proportional to the motor current). Along with built-in protection . At RobotShop, you will find everything about robotics. Sort by Position: Low to High. The new version adds pass-throughs for the four new pins on the Arduino Uno R3.

The MOSFET-based H-bridges are much more efficient than the BJT-based H- bridges used in . Pololu is known for some killer motor driver technology. V and punch out a continuous A (A peak) per motor, or a continuous A (A peak) to a single motor connected to both channels. If you are looking to drive two high-power motors through one compact unit, these dual VNH2SPmotor driver carriers are perfect for you. For even better control, the VNHversion includes current sensing and can operate a . It makes it simple to drive two brushe DC motors.

A Pololu stepper driver board is a well known RepRap machine stepper motor driver. The Pololu stepper driver boards are made as pluggable modules to a electronics motherboard. A good reason of this design is, that it is easy to exchange the Pololu boards when troubleshooting - or when a board has . This version ships fully assembled with connectors soldered in.

This motor driver shield and its corresponding Arduino library make it easy to control two bidirectional, brushed DC motors with an Arduino or compatible boar such as the A-Star 32UPrime.