Arduino programmable thermostat

Up to weekly programs can be stored. Three modality: SET PROGRAM, AUTO MODE, PROGRAM MODETwo PROGRAM modality: ON Mode. It allows manual and programmed setting of temperature, and furnace control. Check out these ideas for creating a home thermostat using the popular Arduino microcontroller platform. Connect your home heater to Internet and chat with it via Telegram!

Want to make your regular old thermostat a smart one?

Good news, you can upgrade that mechanical thermostat with an Arduino and a servo motor. It can also offer some relief for ever- vigilant . The thermostat market has changed since I last bought one. There used to be only four tiers of thermostats : Dumb ones, full manual control of the temperature.

Priced below $(All prices US $). One day programmable ones: assumes every day has the same schedule. Therefore, in the Arduino sketch, all references are to a relay.

It also provides an easy and cheap way of uploading said firmware( s) to the thermostat by emulating a programmer using the widely available Arduino.

But you don't have to go out and buy one. Programmable thermostats are a great way to save both energy and money. You can upgrade your old mechanical thermostat.

All you need is an Arduino microcontroller and a servo motor. The servo is positioned next to the thermostat. Then the rotor of the servo is . Yes, thermostat again but it has real time clock and wireless communication with Ferroli Combi.

One of (master one) measuring temperature, show the temp with LCD and send the temp info to Combi with Arduino Pro Mini. Sure, you can use Arduino Uno, as a matter of size. Like most other DIY thermostats , Ed also used an Arduino board as the main brain of the thermostat and DHTfor sensing ambient temperature and humidity.

For controlling the heater, an electromechanical relay breakout board was used. A 16×character LCD displays the temperature setting that is . Open Source Hardware News. Download the entire project (hardware, software, photos) as a. ZIP archive at this link: drive.

Each of my two thermostats would only need to control a single wall-mounted gas shop heater so a single relay contact would be perfect. This had all the attributes of a simple Arduino -based project.

The dual setpoint thermostat uses off the shelf components whenever possible and the .